14

Technical Support

Last Update vor 5 Monaten

Can I power the Classic / Pro Departure Boards by the USB ports? Configuration says “Demo Config, Serial Locked” Departure Board display goes blank after initialising screen. Departure Board displays CANT CONNECT TO NETWORK / ERROR NO IP / RETRY1 Departure Board says ‘No services available’ when there should be services.

Departure Board display goes blank after initialising screen.

This is caused by the brightness settings being set to 0%. These can be adjusted via the web configuration on the ‘Device’ tab under ‘Device Display’ section.

Was this article helpful?

0 out of 0 liked this article